Multifunctional Child Safety Locks Installation Instructions
A special THANK YOU for your purchase of the Wittle Multifunctional Child Safety Locks! Watch the videos below to see how to install your new cabinet locks and have your house babyproofed in no time!
Important Tips
- Clean and dry the mounting surfaces before installing.
- For maximum strength, allow adhesives to cure for at least 24 hours before use.
- When possible, install out of reach for children and do not install on drywall or wallpaper.
- Carefully plan the desired length before sliding Part A into the locked position. Once it is locked, it cannot be adjusted.
- To remove, heat adhesive with hair dryer for 2-3 minutes until glue loosens and the locks can be separated from the adhesive. You can also use dental floss or fishing line to separate adhesive from surface after heating.
How to Install
How to Remove
How to Readjust
CAUTION - SAFETY WARNING
This product is only a deterrent. It is not a substitute for proper adult supervision. Discontinue use when child is old enough to defeat it. Do not use this product to protect against toxic or dangerous items. Such items should always be stored out of reach of children. Do not touch the adhesive after removing the paper backing. This will cause the adhesive to weaken.